冲孔落料正装复合模运动方仿真(Proe三维图,仿真视频)

冲孔落料正装复合模运动方仿真(Proe三维图,仿真视频)(论文说明书9300字,Proe三维图,仿真视频动画)                                      
摘 要
本设计题目为冲孔落料正装复合模运动仿真设计，体现了带窄凸缘筒形零件的设计要求、内容及方向，极有设计意义。通过对该零件模具的设计，进一步丰富了本人冷冲模设计的基础知识，为今后设计更复杂的冲压模具做好了铺垫并获取了更丰富的经验。 
本设计运用冲压工艺及模具设计的基础知识，首先分析了制件的形状及生产可行性，为合理选取冲压工艺方案做好准备；然后估算了落料毛坯的体积，便于排样；最后分析模具结构，确定模具的设计参数、设计要点及卸料装置的选取。

关键词: 冲压模  运动仿真  动画

The shield blanking and drawing compound dies design
Abstract
The topic of the design is a shield produced by compound blanking and drawing dies, it is according to the requirements ，the contents，also the directions of cylindrical part which has a narrow flange. And it is of great significance. Throughing the die design of this part, my foundation knowledge of die design was enriched a lot. It will be helpful for my later's die-designing which  are more difficult, in addition, I have gain countless experience .
The design using blanking technique and foundation knowledge of die design, first by analysising the shape of the part and feasibility of producing. All  have done are making preparation for reasonable  selection of blanking technique scheme . Then  calculated the volume of the blank flat,so it is simple for layout designing. Finally  anlysised the die structure,confirmed the die designing parameter ，designing essences and selecting tripper.

Keywords: compound blanking, working process, Inventor Studio
 

目   录
1 冲压模及相关软件介绍    1
1.1 冲压工艺简介与分析    1
1.2 Pro/ENGINEER简介    2
1.2.1 Pro/ENGINEER的特点    3
1.2.2 Pro/ENGINEER的模块与功能    4
2 动画设计部分    9
2.1 概述    9
2.2动画创建的一般流程    9
2.3动画创建的过程    9
2.3.1进入动画模块    9
2.3.2创建动画    11
3 心得与结论    25
3.1 心得    25
3.2 结论    25
致谢    27
参考文献    28
 
插图清单
图一 动画模块界面………………………………………………………10
图二 主题选择界面………………………………………………………12
图三 前视图界面…………………………………………………………14
图四 开始与结束界面……………………………………………………17
图五 顶料的界面…………………………………………………………20
图六 卸料后的界面………………………………………………………24